I’m having trouble getting the D size bearing out of my YYR Six for siliconing, could anyone help me with this?? Thank you
here’s your options
-
freeze it, steel doesn’t shrink, but aluminum does, so may be easier to get off
-
get a drill bit or rod almost the exact size of the ID of the bearing to be easier to get off
-
use pliers, but be very careful, more of a last resort
-
If you don’t care about the bearing and none of the above work and you’re hulk smash angry, then grab a pair of vice grips and smash the bearing off… Only done this once lol
Right on the front page of this section there’s a number of posts about removing bearings. A wealth of info in them. Check them out.
Here’s a nice, new fresh one with some good info.
Alternative bearing removal method
That. The new idea is really clever. Check it out.