How does it become unresponsive. I was wondering if i should silicon it but i could not find any videos for it.
To silicone it would be a bad idea AS-IS. It is a sticker recess, not a silicone recess, so it expects a silicone sticker. If you need this done, you can send it to a modder. I had one I purchased modded and painted from xminusmikex and it's amazing, an amazing value and well, it's just freakin' amazing!
1: Clean the bearing. DO NOT LUBE!! Run it dry.
2: Use the larger spacers. I think those are the aluminum ones. Use one on each side, wider gap.
3: Wear down or scrape off the rubber from one of the response stickers so it's pretty much just bare tape.
4: Remove the other response sticker.
Both stickers will make it responsive for the most part. A friend recently got one and it went from "I'm barely responsive" to "Yup, I'm full dead unresponsive" on me while I was playing it, so we succeeded in breaking in the bearing.
Other options are to buy the Terrapin X A+ Beefcake kit for FHZ's. I need to order some bearings anyways, might as well hit him up for some goodies!